Table des Matières
Publicité
Page 6 of 10
FITTING INSTRUCTIONS
Near side (left side as you sit on the motorcycle)
•
Remove the three push rivets arrowed in pictures 1 and 2.
•
Remove the two bolts arrowed in pictures 3 and 4.
•
Remove the push rivet arrowed in picture 5.
•
Remove the bolt arrowed in picture 6.
•
Carefully and gently ease the fairing away from the engine to disengage the
rubber locating stakes as shown in picture 7.
•
Carefully and gently push the fairing rearwards to disengage the locating stakes
as shown in picture 8.
Off side (right side as you sit on the motorcycle)
•
Remove the push rivet arrowed in picture 9.
•
Remove the three bolts arrowed in pictures 10, 11 and 12.
•
Carefully and gently ease the fairing away from the engine to disengage the
rubber locating stakes as shown in picture 13.
•
Carefully and gently push the fairing rearwards to disengage the locating stakes
as shown in picture 14.
•
Offer the downpipe grille (item 1) into position and locate in position using the
two longer button head bolts (item 2) with washers (item 4) as shown in
pictures 15 and 16.
•
Fit two of the nyloc nuts (item 3) to the exposed ends of both threads and
tighten.
•
Refit both fairings as original do not refit the push rivet in position arrowed in
picture 17.
•
Place one of washers (item 4) onto the remaining shorter button head bolt (item
5) then place this assembly through the empty hole as arrowed in picture 17.
•
Use the remaining nut (item 3) and washer (item 4) to secure the bolt as shown
in picture 18 (do not over-tighten as damage can occur, the nyloc nut will hold it
tight).
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G
may make design changes which do not diminish their performance or visual appeal and supplying them in
such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in R&G's order or confirmation and the
Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular
purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care
and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any
defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall
not be liable if the Products have been modified or used or maintained otherwise than in accordance with
R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal
injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the
amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the
Buyer's statutory rights.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 29/11/2019 (NSY)
CONSUMER NOTICE
R&G
www.rg-racing.com
DG0034
Email:
info@rg-racing.com
Publicité
Table des Matières
