R&G FP0141BK Instructions De Montage

Les langues disponibles

Télécharger ce manuel

FITTING INSTRUCTIONS FOR FP0141BK FORK PROTECTORS

THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.

DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.

Please note that the way the kit is packed does not necessarily represent the way of

Please note that in cases where kits are packed with a plastic tube separating components on the

HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY

SPINDLE-BAR (SB024)

(325mm LONG) (x1)

M8 NYLOC NUTS (x2)

BMW F800 GT 2013

mounting to the bike

spindle bar (this tube should be discarded).

SPACER R/H

SPACER L/H

(S0532) (x1)

(S0531) (x1)

TOOLS REQUIRED



Socket set to include 2x 13mm sockets

(

FOR CLARITY OF INSTRUCTIONS ONLY

M8 WASHERS (x2)

)

CRASH-PROTECTOR

(B0445M) (x2)

Page 1 FITTING INSTRUCTIONS FOR FP0141BK FORK PROTECTORS BMW F800 GT 2013 THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. Please note that the way the kit is packed does not necessarily represent the way of...
Page 2 FITTING INSTRUCTIONS  Fit one nut and washer on spindle-bar (SB024) (the end with shorter thread), engage the nut so the plastic insert of nut is fully engaged.  Feed spindle-bar with nut and washer through either crash protector (B0445M) and through the metal spacer (S0531), as shown in the above picture.
Page 3 FITTING INSTRUCTIONS FOR FP0141BK FORK PROTECTORS BMW F800 GT 2013 Le kit contient les articles exposés ci-dessous, vérifier que toutes les pièces soient présentes avant de procéder au montage. La façon dont le kit est emballé ne correspond pas forcément à la façon de monter les pieces sur la moto.
Page 4 Outils requis  2 clés 13mm. INSTRUCTIONS DE MONTAGE:  Installer un écrou et une rondelle sur l’axe (SB024) (l’extrémité avec le filetage le plus court), engager l’écrou de façon à ce que l’insert en plastique de l’écrou soit complètement engagé. ...