Timer Recording; Remote Control Unit; Other Problems - Samsung DVD-R160 Manuel D'instructions

Timer Recording

Timer lamp flickers.
Check if there is enough space in the
Checkpoint 1
disc for recording.
Check whether the current disc is
Checkpoint 2
recordable or not.
Make sure to check before the start
time of recording.
Timer recording does not work properly.
Re-check the recording time and the
Checkpoint 1
end time settings again.
Recording will be cancelled, if the
Checkpoint 2
power is disconnected due to a
power failure or other similar reason,
while recording.
HDMI
No HDMI output.
Check to see that the Video output
Checkpoint 1
is HDMI enabled.
Check the connection between the
Checkpoint 2
TV and the HDMI jack of the DVD
Recorder.
See if your TV supports this
Checkpoint 3
480p/720p/1080i/1080p DVD Recorder.
Abnormal HDMI output screen.
If snow noise appears on the screen,
Checkpoint 1
it means that TV does not support
HDCP (High-bandwidth Digital
Content Protection).
HDMI output Jitter
Check your TV system setup
Checkpoint 1
correctly.
Screen Jitter may occur when the
Checkpoint 2
frame rate is converted from 50Hz to
60Hz for 720p/1080i/1080p HDMI
(High Definition Multimedia Interface)
Output.
Please refer to the user's manual of
Checkpoint 3
your TV.
78 - English

Remote Control Unit

The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Check whether the batteries are
Checkpoint 2
empty.
Other
I forgot my password for parental supervision.
Press the (
Checkpoint 1
your DVD recorder simultaneously
when the power is on. All settings
including the password will revert to
the factory settings. Do not use this
unless absolutely necessary.
(Note that this function is possible only
when no disc is inserted.)
Is it possible to change a subtitle and an
audio signal on a recorded disc?
A recorded disc is played with only
Checkpoint 1
the subtitle and the audio signal
which were selected during recording.

Other problems

Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, and follow the
instructions given.
Turn your DVD recorder off and on.
Checkpoint 2
If the problem still persists, contact a
Checkpoint 3
nearby Samsung service center.
) and ( ) buttons on