Troubleshooting - ASTROS InductWarm 140 Instructions Originales

• Avoid direct contact of the device with food.
• Only use dishes that have been designed as suitable for induction by the manufacturer. Only use dishes
suitable for inductive heating with a minimum bottom diameter of 12 cm/ 4.7". It is possible to use smaller
dishes, but this may have the following effects:
o
Reduced efficiency
o
Potential absence of dish detection
o
Greater radiation
•
Never keep dishes warm without moist food. This poses a risk of the dish overheating.
•
Switch off the InductWarm
using the device. This will prevent unintentional heating in the event that you or someone else places
dishes on the surface above the induction unit.
• Do not heat up tins or other sealed containers, as this can cause an explosion! Items that are unsuitable for
use include any dishes that are not specifically intended for induction appliances, as well as metal splash
guards, aluminium foil, cutlery, jewellery, watches, metallic objects, etc.
•
The induction device is considered to be switched on when the ON/OFF button on the control panel lights
up green.

Troubleshooting

Error
No heat, ON/OFF button
does not light up in any color
No heat, power level button
1, 2, 3 or 4 is flashing blue
Infrared remote control is
not working
Dish does not get warm
enough
ON/OFF button flashes
alternately red and yellow
® 140 unit if you remove the dishes and do not intend to immediately continue
Possible cause
No power supply
Power supply fuse tripped
Device is not switched on
Device is defect
Dish is not detected
Low battery
The transmitter or/and receiver are
dirty
No electrical contact between battery
and remote control
Incorrect placement of dish
Insufficient energy supply
Dish is not suitable for induction
Technical error detected in the device
Elimination of error
Plug the device in,
check the plug connection
Check and reset the fuse
Check the plug connection, turn on
the power switch on the bottom of
the device
Contact customer service
servicepoint@gastros.swiss
Dish is too small, incorrectly placed
or not suitable for induction
Replace the battery
Clean transmitter and receiver
Ensure contact between battery and
remote control
Ensure right position above the
induction coil
Increase power level
Check induction suitability, use
induction-compatible dish
Contact customer service
servicepoint@gastros.swiss
35