Usb Connection - ASTROS InductWarm 140 Instructions Originales

USB connection

Both software updates and system parameter updates can be loaded via the USB port. This task should only be
performed by trained service staff.
Cleaning / Maintenance / Disposal
For cleaning the glass surface switch off the InductWarm
hand temperature before starting to clean!
•
First, use a scraper to remove all large pieces of dirt and food leftovers from the cooking surface.
•
Then squeeze a few drops of a suitable cleaning product on to the cold surface and rub it in with
kitchen paper or a clean cloth.
•
Finally, remove all cleaning product residue, wipe down the cleaned surfaces with water, and rub dry
with a dry cloth.
•
Clean the cooking surface regularly, preferably after each use.
Do not use steel wool or sharp objects for cleaning.
The device is not splash-water resistant. The device must be protected against water splashes and must
not be cleaned with a water jet. When cleaning, always ensure that no liquids can get into the device
itself. For general maintenance and cleaning work at the buffet, the entire buffet must be disconnected
from the mains.
Disposal
This product must be disposed at the recycling centre of electrical and electronic equipment. It must not be
disposed of household or normal waste. With the properly disposing you will help prevent potential
environmental damage or health hazards. For more information on recycling the product, contact your local
municipal office or your waste disposal service.
Devices intended for disposal must not be operated further.
NOTE: The device consists of electrical, electromechanical, and electronic components. There are no batteries
used.
NOTE: The owner and the operator are responsible for the proper and safe disposal of the device.
® 140 built-in device. Wait until the device has cooled to
27