Control Panel Display - ASTROS InductWarm 140 Instructions Originales

Using the infrared remote control (optional): The power level can optionally be set with the infrared
remote control. To do this, the remote control must be held close (approx. 20-30 cm / 8-12") to the infrared
receiver of the external control panel or directly to the internal panel of the device.

Control panel display

ON/OFF button lights up red
ON/OFF button lights up green
Power level button 1 lights up blue
Power level button 2 lights up blue
Power level button 3 lights up blue
Power level button 4 lights up blue
Selected power level button 1, 2, 3 or 4
is flashing blue
The InductWarm ® 140 built-in device has four different power levels that cover different temperature ranges. The
final temperature inside the dish depends on the following factors:
• Quality of the material of the dish (e.g., flat bottom)
• Quality of the inductive layer of the dish
•
Consistency of the food and surrounding temperature
•
Size of the dish
•
Position of the dish on the induction unit
140 built-in device has integrated dish detection to ensure that the induction unit is active
The InductWarm ®
only when there is a dish placed on the device. If the InductWarm
level is displayed. If the vessel is removed, the InductWarm
induction. This is indicated by the button of selected power level 1, 2, 3 or 4 with flashing blue backlighting. If a
vessel is placed back onto the device within 10 minutes (standard setting), the InductWarm
heat at the previously selected level. All inductive dishes can be used with the InductWarm
® 140 built-in device has an integrated temperature protection feature. If the coil
The InductWarm
temperature inside the device reaches the pre-set maximum temperature of 90 °C/194 °F on level 4, the device
automatically resets to level 3. If the temperature rises by another 5 °C / 41 °F despite this initial safety measure,
the device switches off for safety reasons (standby mode). This shutdown serves to protect the dishes and the
®
buffet. The InductWarm
threshold described above (the device must be restarted manually after the temperature drops below 90 °C /
194 °F, and this can take a few minutes).
140 can only be operated again when the coil temperature has dropped below the
Function
Device is supplied with power
Device is running in standby mode
Power level 1 is activated
Power level 2 is activated
Power level 3 is activated
Power level 4 is activated
There is no dish on the device or
the dish is not detected
® 140 device detects a dish, the selected power
® 140 system detects this and switches off the
® 140 continues to
® 140 unit.
25