ASTROS InductWarm 140 Instructions Originales page 24

You can link up to three InductWarm
them with the power cord (article 6 01 10x 00) to a power outlet 100-240 VAC (16 A). When using
a power outlet with only 10A, you can link up to two InductWarm
consumption of one induction unit is 800W. It is recommended to connect the devices to the power supply
via a circuit breaker (max. 16 A).
Installation
Remove all packaging and check your device for visual damage. Do not start up the unit if there are any signs of
damage. Power on the InductWarm
"0" on the power switch indicates that the device is switched off).
The device is supplied with power when the ON/OFF button on the control panel lights up with red
backlighting.
The InductWarm
green backlighting. The power regulation is carried out as described below.
Operation
®
The InductWarm 140 built-in device can be controlled in different ways:
Using the control panel: The internal control panel is located at the front of the induction unit. An additional,
external control panel can be used as an option. If an external panel is connected, the internal panel will no longer
function. Press the 1, 2, 3 or 4 button to select the respective power level. The selected power level button lights up
with blue backlighting.
24
® 140 units with the power chain cable (Article No. 6 10 1xx 00) and connect
® 140 by using the power switch on the bottom of the device (the number
® 140 is activated by pressing the ON/OFF button. The ON/OFF button lights up with
ON/OFF button Selected power level
® 140 devices. The maximum power
Infrared receiver