Troubleshooting; Safety Regulations - ASTROS InductWarm 200 Mode D'emploi

Troubleshooting

Possible problems
Fault
No heat, LED is not blinking
No heat, LED flashing
Dish is not warm enough

Safety Regulations

Responsibility
®
The InductWarm 200 reflects the state of the art and has been built in accordance with the valid CE guidelines.
Safe operation is assured. Children should be supervised to ensure that they do not play with the appliance.
Gastros Switzerland AG disclaims all liability in cases due to unauthorized conversions or modifications by the
customer. If the mains supply cable for the device is damaged, it must be replaced by the manufacturer, an
authorized service agent or other similarly qualified person in order to prevent hazards. The connection for the
mains plug should always be positioned so that it is freely accessible. If this is not possible, a master switch for
the device must be installed by the customer. In the event of a malfunction, the device must be switched off
completely by unplugging the mains plug or by turning off the master switch.
26
Cause
No power supply
Power line fuse tripped
Device not switched on
Device defect
Dish is not detected
Incorrect placement of dish
Too little energy input
Dish is not induction compatible
Remedy
Plug the device in, check the
connector
Check and reset the fuse
Switch on device with the on / off
switch
Contact customer service
servicepint@gastros.swiss
Pan too small or not induction
compatible
Ensure right position above the
induction coil
Increase power level
Check and use induction compatible
dish