CAME SALOON Manuel D'installation page 53

Transferring parameters from MASTER to SLAVE
Only the following parameters are copied:
- opening and closing maneuvering speeds;
- opening and closing slow-down speeds;
- opening and closing slow-down points;
- slow-down and travel sensitivity;
- calibrating speed.
To transfer the parameters from MASTER to SLAVE control
board, proceed as follows:
- select function F 52 on the MASTER control board.
- select 1 and press ENTER.
Note: with system that require the MASTER and
the SLAVE to have different parameters, make
the settings directly on to each control board.
Travel calibration
Calibrate the MASTER control board
Select A 3 and press ENTER to confirm.
Select 1 and press ENTER to confirm the travel calibration
operation.
The leaves will perform a
slowed down maneuver until
the come to a full stop.
The leaves will perform an inverted maneuver until the come to
a full stop.
a 3
c l i
F 5 2
i
ESC < > EN EN ENTER
ESC < > ENTER
i
o p I
ESC < > ENTER
ESC SC SC SC < < < < > > > > EN EN ENTER