CAME SALOON Manuel D'installation page 48

Motors test
Always start programming the turnstile from this procedure.
Activate procedure A 2, see Functions detail table.
After pressing, the
appear.
Keeping the button pressed,
that the turnstile performs a CLOCKWISE
maneuver.
Then, use the button
the turnstile performs a COUNTER
CLOCKWISE maneuever.
With an entry direction other than the default one (see function F-54) the direction of opening could be
inverted.
If the rotations are correct, move on to travel calibration.
Travel calibration
Before calibrating the travel, check that the maneuvering area is free of any obstructions.
During the calibration, all of the safety devices will be disabled except for the Total Stop.
Activate procedure A 3, see Functions detail table.
After pressing, the
perform a clockwise movement until it
mechanically stops.
Then an inverted movement until the final
mechanical stop.
Wait a few seconds for the registrations to
appear on the display.
The leaf closing position is established as the bisector of the final closing stops.
waiting [ ] will
- - -
check
c l I
to check that
o P I
leaf will
c l i
o p I
ESC < > ENTER
ESC < > ENTER