CAME SALOON Manuel D'installation page 45

Programming
Description of programming commands
18
Menu map
Start programming by first performing functions A 2 Motor test and A 3 Travel calibration.
F 1 Total stop
F 2 Setup input 2-CX
F 3 Setup input 2-CY
F 19 Automatic closing
F 21 Preflashing
F 28 Opening speed
F 29 Closing speed
F 30 Opening slow-down
F 31 Closing slow-down
F 34 Travel sensitivity
F 35 Slow-down sensitivity
F 49 Operation
F 50 Saving data
F 51 Read data
F 52 Copy parameters from Master to Slave
F 53 AntiPassBack
F 54 Entry direction
Display for viewing
functions and settings
that are assigned via the
programming buttons.
The button
• entering the programming
• entering the single menus
• confirming/memorizing the set value
The key are for
• moving from one item to another
• increasing or decreasing values
The key is for exiting menus without
saving the changes
F 55 Standard alarm
F 56 Peripheral number
F 57 Offset closing limit-switch
F 62 Automatic restoring
F 70 Additional alarm
F 72 Change state of safety contacts
U 1 Memorizing a user
U 2 Deleting a user
U 3 Deleting all users
A 2 Motor test
A 3 Calibrating boom travel
A 4 Resetting parameters
H 1 Firmware version
is for