IWC Schaffhausen 3950 Mode D'emploi page 27

S E T T I N G Y O U R W A T C H C O R R E C T L Y
Important note: The rotating bezel must be pushed down com-
pletely and turned simultaneously in order to be adjusted.
To set your watch correctly, proceed as follows:
– Turn the rotating bezel until the time zone you are in is at
"12 o'clock" (above the triangle on the dial). If it is summer time
in the time zone in question, you must set the corresponding
dot with the letter "S" to the "12 o'clock" position. Ensure that
the rotating bezel noticeably clicks into the selected position.
– Release the crown by turning it to the left.
– Wind the movement (approximately 20 clockwise revolutions of
the crown).
– Pull out the crown to position 1. This will stop the movement.
To set the time accurately to the second, it is best to stop the
movement as the seconds hand passes 60.
– Turn the hands forwards or backwards until the date display
shows the current date.
– Turn the hands further until they show the local time. Ensure
that the 24-hour display also shows the correct time. Other-
wise, you must turn the hour hand 12 hours further.
P I L O T ' S W A T C H T I M E Z O N E R C H R O N O G R A P H
— 2 7 —