CAME BY-3500T Manuel D'installation page 34

Selecting the functions
1 ON
- AUTOMATIC CLOSING function activated
2 ON
- OPEN-STOP-CLOSE-STOP function from the transmitter and/or the button (2-7) activated
2 OFF
- OPEN-CLOSE function from the transmitter and/or the button (2-7) activated
3 ON
- OPEN ONLY function from the transmitter activated
4 ON
- HOLD-TO-RUN function activated
5 ON
- PRE-FLASHING during opening and closing activated
6 ON
- OBSTACLE DETECTION function activated
7 OFF
- REOPENING during closing (2-C1) function activated
8 OFF / 9 OFF - RECLOSING during opening (2-CX) function activated
8 OFF / 9 ON
- PARTIAL STOP function (2-CX) activated; (if the devices are not connected on 2-CX, set dip switch 8 to ON)
10 OFF
- TOTAL STOP function with button (1-2) activated
11
- Not used, keep the dip switch in the OFF position
12 ON
- PARTIAL OPENING function activated; automatic closing occurs after a set time of 8 seconds.
12 OFF
- PARTIAL OPENING function activated; automatic closing, if envisaged, occurs after a time that can be set at between 1 and 14 seconds
using the trimmers.
13 ON
- Safety test function to check photocell efficiency activated; (13 OFF - disabled)
14
- Not used, keep the dip switch in the OFF position
15
- Not used, keep the dip switch in the OFF position
16 ON
- COURTESY LAMP function activated
17 ON
- CYCLE LAMP function activated
18
- Not used, keep the dip switch in the OFF position
19
- Not used, keep the dip switch in the OFF position
20
- Not used, keep the dip switch in the OFF position
Adjustments
ACT trimmer
-
PART.OP. trimmer
-
Adjustment of the AUTOMATIC CLOSING time: from a minimum of 1 second to a maximum of 120 seconds.
Adjustment of the PARTIAL OPENING time from a minimum of 1 second to a maximum of 14 seconds.
+T.C.A-
+AP.PARZ.-