CAME BY-3500T Manuel D'installation page 35

Activating the radio control
Connect the antenna RG58 cable to the terminals and any accessory to connect to the B1-B2 output (N.O. contact) ❶.
For the AF43S / AF43SM radiofrequency cards only, position the jumper as shown according to the series of transmitters used ❷.
DISCONNECT POWER AND REMOVE THE BATTERIES, IF PRESENT. Insert the AF card on the control board.
N.B. the control board only recognises the AF card when the operator is powered again❸.
Hold down the CH1 key on the control board: the LED indicator flashes. Press a key on the transmitter to send the code. The LED will remain lit to indicate
SUCCESSFUL memorisation ❹.
Follow the same procedure with the CH2 key, associating it with another transmitter key ❺.
CH1 = channel for direct control of a panel function (OPEN ONLY, OPEN-CLOSE-REVERSE or OPEN-STOP-CLOSE-STOP, according to the selection made on dip
switches 2 and 3).
CH2 = channel for commands directed to an accessory device connected on B1-B2 or for connecting two coupled motors having a single command.
❶
Contact rating: 5 A-24 V DC
❷
TOP
TAM
❹
Indicator LED
❸
Antenna
❺
Control board
AF card