The gearmotor is designed to be powered at 400 V three-phase.
With 230 V three-phase power supply.
Remove the control panel, the mounting bracket and the connection cover.
Changing the connections of the gearmotor contacts. Replace the control panel and, on the control board, move the short circuit bridge from the 400 V terminal to
the 230 V terminal.
Control panel power supply
230/400 V AC - three-
phase
Connecting the gearmotor and end run
The motor is designed to be installed on the left, inside view.
If installing on the right, inside view, reverse the motor and end run terminals on the control panel.