Troubleshooting - AEG FAVORIT 99015 VI Notice D'utilisation

44

TROUBLESHOOTING

The appliance does not start or it stops
during operation.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
Service.
Display
OPEN THE TAP
DRAIN BLOCKED
SERVICE CODE
WARNING!
Deactivate the appliance before
you make the checks.
Problem
The programme
does not start.
The appliance does
not fill with water.
Time Beam
Possible cause
The mains plug is not con-
nected in the mains socket.
The appliance door is open.
The display shows the mes-
sage PLEASE CLOSE
DOOR .
You did not press OK
START.
The fuse in the fuse box is
damaged.
The delay start is set.
The water tap is closed.
The water pressure is too
low.
The water tap is clogged or
there is limescale on it.
The filter in the water inlet
hose is clogged.
The water inlet hose has a
kink or a bend.
The anti-flood device is on.
There are water leakages in
the appliance.
With some problems, the display
shows a message and the Time Beam
shows an alarm code.
Problem
The appliance does not
fill with water.
The appliance does not
drain the water.
The anti-flood device is
on.
Possible solution
Connect the mains plug.
Close the appliance door.
Press OK START.
Replace the fuse.
Cancel the delay start or
wait for the end of the
countdown.
Open the water tap.
Contact your local water au-
thority.
Clean the water tap.
Clean the filter.
Make sure that the position
of the hose is correct.
Close the water tap and
contact Service.