Troubleshooting - AEG FAVORIT 45020 VI1P Notice D'utilisation

30 www.aeg.com
9.2 Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.
9.3 External cleaning
Clean the appliance with a moist soft
cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
Alarm code
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 1 time in-
termittently.
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 2 times in-
termittently.
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 3 times in-
termittently.
6. Make sure that the filter (B) is cor-
rectly positioned under the 2 guides
(C).
7. Assemble the filter (A) and put it
back in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
9.4 Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits of
grease and limescale inside the appli-
ance.
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
With some problems, different indica-
tors flash continuously or intermittent-
ly at the same time to show an alarm
code.
Problem
The appliance does not fill with water.
The appliance does not drain the wa-
ter.
The anti-flood device is on.