Cleaning The Spray Arms; External Cleaning; Troubleshooting - AEG FAVORIT 99025 IM0P Notice D'utilisation

36 www.aeg.com

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.

9.3 External cleaning

Clean the appliance with a moist soft
cloth.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
Display
Attention: no intake of water possible.
Please ensure the tap is not closed or
blocked.
Attention: water is not draining. Please
ensure the drain tube is not attached
wrongly.
Attention: The antiflood system has
been activated.
All manuals and user guides at all-guides.com
A1
A2
2. To disassemble the filter (A), pull
apart (A1) and (A2).
3. Remove the filter (B).
4. Wash the filters with water.
5. Put the filter (B) to its initial position.
Make sure that it assembles correct-
ly under the two guides (C).
6. Assemble the filter (A) and put it in-
to position in filter (B). Turn it clock-
wise until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
With some problems the display
shows a message.
Problem
The appliance does not fill with wa-
ter.
The appliance does not drain the wa-
ter.
The anti-flood device is on.