Technical Information - AEG FAVORIT 45020 VI1P Notice D'utilisation

32 www.aeg.com
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
"Setting and starting a programme".
2. Press and hold, at the same time,
programme button
gramme button
tors of programme buttons

11. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
until the indica-
and start to flash.
Width / Height / Depth
(mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
1)
Cold water or hot water
Place settings
Left-on mode
Off-mode
3. Press programme button
• The indicators of programme but-
• The indicator of programme but-
• The end indicator is off.
4. Press programme button
end indicator comes on. The rinse
aid dispenser is activated.
5. Press the on/off button to deactivate
and pro-
the appliance and to confirm the set-
ting.
6. Adjust the released quantity of rinse
,
aid.
7. Fill the rinse aid dispenser.
tons and
ton continues to flash.
596 / 818 - 898 / 550
(0.5 / 0.05 ) / (8 / 0.8 )
2)
.
go off.
. The
220-240 V
50 Hz
max. 60 °C
12
0.10 W
0.10 W