Checking The Battery Charge Level; Changing Tools; Torque Selection Ring/Drill Setting; Speed Gearbox - Parkside PABS 20-Li D5 Traduction Des Instructions D'origine

Checking the battery charge level

♦ Press the battery charge level button
the charge level of the battery (see Fig . E) . The
status/remaining charge will be shown on the
battery display LED
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Changing tools

Your cordless drill has a fully automatic spindle
lock .
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it . After you have attached the desired tool
and tightened it by turning the chuck
continue working (see Fig . F) . The spindle lock is
automatically released when the motor starts (ON/
OFF switch pressed) .

Torque selection ring/drill setting

You can set the torque using the torque selection
ring (see Fig . G) .
♦ Select a low level for small screws or soft
materials .
♦ Select a high level for large screws, hard
materials or removing screws .
♦ Select the drill setting for drilling work by
adjusting the torque selection ring
position (see Fig . H) .

2 speed gearbox

CAUTION!
► Only operate the gear selection switch
when the appliance is at a standstill . Other-
wise the appliance can be damaged .
In first gear (gear selector switch
position 1) (see Fig . I)
you can reach a speed of approx . 400 rpm and a
high torque . This setting is suitable for all screwing
jobs .
PABS 20-Li D5
to check
as follows:
, you can
to the
in
In second gear (gear selector switch
position 2) (see Fig . J)
you can reach a speed of approx . 1400 rpm for
carrying out drilling work .

Operation

Switching on and off

Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in (see Fig . K) .
The LED work light
OFF switch is depressed lightly or fully . This
allows for illumination of the work area in low
lighting .
Switching off
♦ Release the appliance's ON/OFF switch
switch off the appliance .

Adjusting the rotational speed

The ON/OFF switch
control . Pressing the ON/OFF switch
yields a low speed . Increasing pressure increases
the speed (see Fig . K) .
NOTE
► The integrated motor brake ensures rapid
stoppage .

Changing the direction of rotation

♦ Change the direction of rotation by pressing the
rotational direction switch
right (see Fig . L) .
in
lights up when the ON/
has a variable speed
lightly
towards the left or
GB │ IE │ 21
to
■