Tips And Tricks; Maintenance And Cleaning - Parkside PABS 20-Li D5 Traduction Des Instructions D'origine

Tips and tricks

Tip! This symbol indicates proper
behaviour!
♦ Before operation, check whether the screw or
drill bit is correctly positioned, i .e . centred in the
drill chuck .
♦ Screw bits are labelled according to their
dimensions and their shape . If you are uncertain,
always check whether the bit fits tightly in the
screw head without any free play .
Torque
♦ Smaller screws/bits can be damaged if you set
the torque or rotational speed too high .
Hard screw joints (in metal)
♦ Particularly high torques occur, for example, in
metal screw joints made using drive sockets .
Select a low rotational speed .
Soft screw joints (e.g. in soft wood)
♦ Again, use a low rotational speed, to avoid e .g .
damaging the surface of the wood upon contact
with the screw head . Use a countersink .
When drilling in wood, metal and other
materials, observe the following
♦ Use a high speed for drill bits with small diameter
and a low speed for drill bits with large diameter .
♦ Select a low speed for hard materials and a
high speed for soft materials .
♦ Secure or fasten the workpiece in a clamp or
vice (if possible) .
♦ Mark the spot where you want to drill using a
centre punch or nail . Select a low rotational
speed when starting .
♦ Pull the rotating drill bit from the hole repeatedly
to remove dust and chips and clear the hole .
■ 22 │ GB │ IE
Drilling in metal
♦ Use a metal drill (HSS) . For optimum results,
cool the drill bit with cutting oil . Metal drill bits
can also be used to drill into plastics . Start with
a 3 mm diameter drill bit and then increase the
size until the desired hole diameter is achieved .
Drilling in wood
♦ Use a wood drill with a lathe centre; for deep
holes, use an auger bit; for large-diameter
holes, use a Forstner bit . Small screws can be
screwed directly into soft wood .

Maintenance and cleaning

WARNING! RISK OF INJURY!
Always switch the appliance off and
remove the battery before carrying
out any work on the appliance.
The cordless drill is maintenance-free .
■ The appliance must always be kept clean, dry
and free from oil or grease .
■ Never allow liquids to get into the appliance .
■ Use a soft, dry cloth to clean the housing .
Never use petrol, solvents or cleansers which
can damage plastic .
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
NOTE
► Replacement parts not listed (such as batteries,
switches) can be ordered via our service
hotline .
PABS 20-Li D5