Operation; Removing/Inserting The Battery; Checking The Battery Charge Level; Recharging The Battery - Parkside PBSA 12 D4 Traduction Des Instructions D'origine

your battery and char-
ger from the Parkside
X 12 V Team series. A
detailed description of
the charging process and
further information can
be found in the separate
operating instructions.

Operation

Remove the rechargeable
battery from the device to
prevent accidental operation.
Risk of injury!
Ensure that the ambient tem-
perature does not exceed
50°C or fall below -20°C du-
ring work.
Removing/inserting
the Battery
1. To remove the battery (10) from the ap-
pliance, press the release button (11)
on the battery and pull out the battery.
2. To insert the battery (10), place it on
the guide track and push it into the ap-
pliance. It will audibly snap in.
Checking the battery
charge level
10) charge level is indi-
The battery's (
cated by the charge state indicator (
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red => Battery needs to be charged

Recharging the battery

Allow a hot battery to cool before
charging.
Charge the battery (
only the red LED on the level indica-
tor is illuminated.
charging
time (hour)
PLGK 12 A1
PLGK 12 A2
PLGK 12 B2
1. Remove the battery (
appliance if necessary.
2. Plug the battery charger (
mains outlet.
3. Insert the battery (
ing compartment of the battery charger
13).
(
4. Pull the battery (
tery charger (
5. Unplug the battery charger (
from the mains.
Overview of the LED indicators on
the charger (13):
Green LED illuminated while the
rechargeable battery is not inserted:
Charger is ready
Green LED lights up: Battery is charged
4).
Red LED lights up: Battery charging
Red LED flashes: Error
7).
GB
10) when
PAPK 12 A1 PAPK 12 B1
PAPK 12 A2 PAPK 12 B2
1
1
0,5
10) from the
13) into a
10) in the charg-
10) out of the bat-
13).
IE
2
2
1
13)
27