Initial Start-Up; Checking The Battery Charge Level; Inserting/Removing The Device's Battery Pack; Selecting A Tool - Parkside PBHA 12 A1 Instructions D'origine

GB IE
9) RESIDUAL RISKS
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and the
manufacturer of their medical im-
plant before operating the machine.

Initial start-up

Place the rotational direction switch
into the central position before car-
rying out any work with the electri-
cal tool (e.g. maintenance, change
of tool etc.), as well as during trans-
portation and storage. There is a
risk of injury if the on-off switch is
accidentally activated.
Checking the battery charge
level
The battery's (
cated by the charge state indicator (
26
9) charge level is indi-
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow
red
For more information about the
rechargeable battery and charger,
please read the instruction manual
for your Parkside X 12 V Team se-
ries rechargeable battery.
Inserting/removing the device's
battery pack
Inserting the battery pack:
• Push the rotational direction switch
( 7) into the central position (lo-
cked). Allow the battery pack (
latch into the handgrip.
Removing the battery pack:
• Press the button (
remove the battery pack (

Selecting a tool

An SDS Plus attachment tool is required for
impact drilling.
Use the keyless chuck with SDS Plus adap-
ter for drilling without impact into wood,
metal, ceramic and plastic.
You can insert cylindrical drill bits with a
diameter of 0.8 - 10 mm into this chuck, or
an attachment tool with a hexagonal shaft.
For screwing, use the screw bits that are
inserted via the keyless chuck with SDS
6). Plus adapter.
=> Battery half charged
=> Battery needs
to be charged
10) to unlock and
9).
8).
9) to