Operation; Setting Up; Selecting The Speed - Parkside PTBM 500 E5 Traduction Des Instructions D'origine

10. Fold the safety device (6) up-
wards. Insert the chuck (4) on
the taper of the drill spindle (7).
Push the drill chuck onto the drill
chuck tip with a few light taps.
Use a plastic hammer for this
purpose.

Operation

Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work and that
you do not endanger other peo-
ple.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device.
Spindle-side drive
pulley (
Pos.
1. D - I
2. D - II
3. C - I
The gear cover (3) is equipped with a interlock switch (32). If the gear cover (3) is
not closed correctly, the device cannot be switched on.
6. Using the lever (33), slide the motor
unit (13) backwards to re-tighten the V-
belts (29).
30)
A
B
C
D
speed
Pos.
[1/min]
500 4. D - III
680 5. B - I
770 6. C - II

Setting up

Place the bench drill on a solid surface.
Ideally, bolt the drill to the surface. Use the
four holes in the baseplate (17) for this.

Selecting the speed

1. Release the locking bolt (11) on the
gear cover (3).
2. Open the gear cover (3).
3. Release the retaining screw (12) on the
motor unit (13).
4. Using the lever (33), slide the motor
unit (13) forwards a little to release the
load on the V-belts (29).
5. Place the V-belts (29) on the desired
assembly to reach the specified speed:
Motor side drive
pulley (
I
II
III
speed
Pos.
[1/min]
830 7. B - III
980 8. A - II
1100 9. A - III
7. The V-belts (29) are correctly tensioned
when they give way slightly when
pressed.
GB
IE
31)
speed
[1/min]
1600
2000
2500
31