Oceanic OCEACLIM120W Mode D'emploi page 32

2）insert the heat pipe assembly (the end of the exhaust joint) into the back panel vent slot (push to the
left) and complete the assembly (as shown in figure 1).
1.2 Installation of window sealing plate components
1）Half open the window，and mount the window sealing plate assembly to the window (as shown in Fig.2 and
Fig.3).Components can be placed in horizontal and vertical direction.
2）Pull various components of the window sealing plate assembly open, adjust their opening distance to bring
both ends of the assembly into contact with the window frame, and fix various components of the
assembly.1.2 Install the window sealing plate assembly
Notes:1）the flat end of the exhaust pipe joints must be snapped into place.
2)The pipe cannot be distorted nor has substantial turning (greater than 45 °). Keep the ventilation of the exhaust pipe not
blocked.
1.3 Install the body
1）Move the machine with installed heat pipe and fittings before the window, and the distance between the body
and walls or other objects shall be least 50 cm (as shown in Fig.4).
3）Elongate the exhaust pipe and snap the flat end of the exhaust pipe joints into the hole of the window sealing
plate assembly (as shown in Fig.5 and Fig.6) .
Notes：1、the flat end of the exhaust pipe joints must be snapped into place.
2、The pipe cannot be distorted nor has substantial turning (greater than 45 °). Keep the ventilation of the exhaust
pipe not blocked.
Figure 2 Figure 3
Figure4
10