Automatic Humidifier Operation; Maintenance And Service - Empire Comfort Systems Mantis Instructions D'installation

AUTOMATIC HUMIDIFIER OPERATION

The Mantis Power-Vent High-Efficiency Fireplace has an automat-
ic humidifier designed into the fireplace. As the fireplace operates,
condensate is created and is collected in a tank inside the fire-
place. The condensate pump will take the collected condensate
and pump it to a stainless steel tray where it evaporates into the
airstream, adding humidity to the heated space.
Note: When the automatic humidifier is engaged and is transfer-
ring the condensate, there may be a noticeable hissing sound.
This is normal, and the sound should persist for less than 30 sec-
onds.
The amount of condensate created will vary based on several
factors including but not limited to location of fireplace, air tem-
perature, length of venting, and whether the vent pipe is horizontal
or vertical. The humidifier will operate intermittently while the fire-
place is operating.
While the condensate pump is transferring the condensate from
the tank to the tray, the "AUX" symbol will display during pump
operation. See Page 26, Figure 40. Once the condensate is trans-
ferred, the symbol will turn off.
The Mantis should be inspected and serviced annually by a quali-
fied service person. This will ensure that the appliance is operating
safely and efficiently. Should you suspect any abnormal opera-
tion, contact a service person that has been trained to service this
product.
Cleaning the Glass Door
After the initial paint curing, a slight film may form on the glass. It is
recommended to clean the glass with gas fireplace glass cleaner.
The glass will need to be cleaned periodically during the year. Use
care when removing and cleaning the glass. In the event the glass
needs replaced, contact a qualified service person. Only glass ap-
proved by Empire Comfort Systems Inc. may be used, any substi-
tute glasses will void the warranty.
CAUTION
Do not attempt to clean the glass when it is hot. Do
not strike or hit the glass.
WARNING
Do not operate this appliance without the glass door
in place. Do not operate if the glass front is broken or
damaged. Do not use the glass door if the gasket is
missing or is damaged.
CAUTION
Be certain the glass is cool before handling.
Page 36
All manuals and user guides at all-guides.com
MAINTENANCE & SERVICE
Figure 55
Removing the Glass Door
1. Remove the lower louvered panel by lifting up then pulling
out.
2. Release the two hinge clips on underside of firebox.
3. Angle the bottom of glass assembly approximately 60 de-
grees out from firebox. Gently pull glass assembly away from
firebox. Do not damage or remove the gasket from the door.
Resetting the Fireplace
WARNING
Potential risk of fire, electric shock, and personal injury.
Take precautions to reduce such risks
CAUTION
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
To reset the fireplace, press the mode selection button on the dis-
play panel repeatedly until the fireplace cycles through the "OFF"
setting once. If the error has been cleared, the fireplace will oper-
ate normally. If the error is still present, consult a qualified service
technician.
Cleaning the Porcelain Liners
Over time a film may form on the porcelain liners. It is recommend-
ed to clean the liners with gas fireplace glass cleaner. The liners
will need to be cleaned periodically during the year. The glass door
will need to be removed to clean the liners. Use care when remov-
ing the glass. In the event the liners need to be replaced, contact
a qualified service person. Only liners supplied by Empire Comfort
Systems may be used. Any substitute will void the warranty.
31793-3-1015