Empire Comfort Systems Mantis Instructions D'installation page 29

Masquer les pouces Voir aussi pour Mantis:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2
13
15
14
16
1
MAN
AUTO
PILOT
3
4
Index
Description
No.
Remote function mode symbols
1
(MANUAL - AUTOMATIC - PILOT)
2
Symbol for remote communication to fireplace
Keypad lock symbol. This symbol appears when keypad is
3
locked.
Low battery symbol. When this symbol appears without
4
flashing, the batteries must be replaced.
The temperature currently measured by the remote con-
5
trol's built-in sensor for the area around the remote control.
Temperature units of measurement
6
(Celsius - Fahrenheit).
Symbol identifying room temperature measured by the
7
built-in sensor.
The thermostatic mode set temperature. This symbol does
8
not appear in MANUAL mode.
Clock. The clock functions as a countdown when the
9
SLEEP function is in use.
10
Symbols indicating the current day.
TIMER symbol. If this symbol does not appear, the TIMER
is not active. If only the outline of the symbol appears, the
11
TIMER is active. A solid black symbol indicates that you are
in the TIMER setting menu.
SLEEP function symbol. If this symbol does not appear, the
SLEEP function is not active. If only the outline of the
symbol appears, the SLEEP function is active, meaning
12
that the stove will switch off at the end of the countdown
period set by the user and shown by symbol 9. A solid black
symbol indicates that you are in the SLEEP setting menu.
Flame symbol, indicating the current flame power. If flame
13
power is at level 5, the MAX message also appears.
Clock setting symbol. When this symbol appears, you can
14
adjust the clock setting displayed by the digits 9.
Flame power bars: one bar = low, 5 bars = high. These
15
bars only appear when the stove is in MANUAL mode.
Digits identifying the weekly TIMER program currently
16
selected.
Figure 42 - The Remote Control Display
31793-3-1015
All manuals and user guides at all-guides.com
REMOTE INSTRUCTIONS
12
11
10
9
8
6
6
5
7
NOTE: The program symbol
flame symbol
can appear in two ways: Solid black or Outline
Solid symbols indicate that you are currently in that function's set-
ting menu.
For example, If the sleep symbol
you are currently in the sleep timer setting menu and can use the
up and down button (E in Figure 43)to change the sleep timer.
Figure 43
Outline symbols mean that the function is active but that settings
cannot be changed unless you first enter the setting menu. When
you enter the setting menu, the symbol turns solid black again.
For example, If the sleep symbol appears only in outline, the sleep
timer is active and functioning.
Battery Type and Replacement
The batteries are housed in the base of the remote control. The
device requires three AAA 1.5V batteries. The Low Battery Symbol
on the remote control display tells you when the batteries
are running out. If the low batteries symbol
batteries are nearly discharged and the remote control is about to
lose power.
ATTENTION
The batteries may need to be replaced frequently due to the
remote control's multiple functions.
CAUTION
When replacing the batteries, take care to respect the polarity
symbols inside the remote control's battery compartment.
, sleep symbol
, and
appears in solid black,
E
appears, the
Page 29

Publicité

Table des Matières
loading

Table des Matières