Empire Comfort Systems Mantis Instructions D'installation page 34

Note: If the keypad is not used for seven seconds, the remote
control automatically exits the program menu and assumes the
last settings entered in the program menu..
Press the "O" button again to confirm your choice and exit the
program menu. The CLOCK symbol
outline on the remote control screen.
When the outlined clock symbol is displayed, a program is active
and the fireplace will be started up and shut down at set times ever
day of the week.
IMPORTANT! When program mode is active, the clock symbol
is displayed on all screens of the remote control. PRO-
GRAM mode can be activated/deactivated with the fireplace
functioning or shut down.
You can start up or shut down the fireplace manually even if a pro-
gram is active. Manual commands take precedence over program
commands. The next program command will be ignored.
Example: if the timer is due to start the fireplace at 10:00, but you
already feel cold at 9:00 and want to start the fireplace up early,
press the up and down button. The command to start the fireplace
at 10:00 will then be ignored because the fireplace will already be
functioning.
The chart below outlines the timing of the ten pre-set programs. The shaded areas show the time when the appliance would
be ON.
Weekly Program
No. Days
Mon - Fri
P01
Sat - Sun
Mon - Fri
P02
Sat - Sun
Mon - Fri
P03
Sat - Sun
Mon - Sat
P04
Sun
Mon - Sat
P05
Sun
Mon - Fri
P06
Sat - Sun
Mon - Fri
P07
Sat - Sun
Mon - Fri
P08
Sat - Sun
Mon - Fri
P09
Sat - Sun
Fri
P10
Sat - Sun
Page 34
All manuals and user guides at all-guides.com
REMOTE INSTRUCTIONS
remains displayed in
Table, Figure 54
Deactivating PROGRAM mode
To deactivate PROGRAM mode, enter the program setting menu.
The clock symbol
button to select "OFF."
Wait seven seconds or press the "O" button again to confirm the
setting. Program mode is now deactivated, and the clock symbol
will be gone.
Timetable
will appear. Use the up and down
31793-3-1015