What If The Projector You Want Does Not Appear; Connecting In Ip Connect Mode - Epson EasyMP EMP-7850 Guide De Mise En Route

What If the Projector You Want does not Appear?

If the projector to which you want to connect does not appear on the projector
selection screen of EMP NS Connection, please check the following:
• If connecting with a wireless LAN, is the wireless LAN signal weak, or not
being received at all?
• Is the connection mode set up correctly?
• Are the subnets different ?
When using Easy connect mode:
• Are the computer and projector setup with the same ESSID
• Are the computer and projector setup to use the same channel
In the event that you are connecting the projector on a network where the subnets
differ, you can use "IP connection mode" to establish a connection.
IP connection mode works by using the IP address
connection.

Connecting in IP Connect Mode

Perform the following steps to connect using IP connection mode.
Tip :
• The projector name will not be displayed in the projector selection screen of EMP NS
Connection if the projector's IP address and the computer's IP address belong to a
different subnet.
• If you click on the "
with an explanation of the functions of that screen.
Caution :
• Do not unplug the power cable when EasyMP is in use (screens are changing or the
access lamp on the wireless LAN card slot is lit green).
• Do not remove the wireless LAN card when the access lamp on the wireless LAN card
is lit green, or when connected to a network. Doing so may damage the wireless LAN
card.
• For information about the Wired LAN card access lamp(s), refer to the documentation
of the wired LAN card you are using.
56
" icon of any EMP NS Connection screen, help will be displayed
?
?
of the projector to establish a