Connecting In Access Point Mode Or Wired Lan Connection Mode; Before Connecting - Epson EasyMP EMP-7850 Guide De Mise En Route

Connecting in Access Point Mode or Wired LAN Connection Mode

In addition to the Easy Connect mode, there is also the Access point mode and
Wired LAN connection mode for connecting a computer to a projector via a
network.
Access point mode is a mode for connecting a projector to a computer through a
wireless LAN access point on an existing network system.
Wired LAN connection mode is a mode for connecting a projector to a computer via
wired network system. When a wired LAN card is set into the projector, a network
cable is used to connect with a computer participating in a network.
When using a computer connected through an access point, or a company's network
systems, under normal circumstances for both modes, the computer's LAN settings
remain unaltered, and only the projector is set up.
In addition to being able to project computer images using the projector, you can
use EMP Monitor and Mail Notification Function to monitor the status of the
projector from a computer.
the EasyMP Operation Guide
Since the method of connection is almost the same, both Access point mode and
Wired LAN connection mode are explained together here.

Before Connecting

Ensure the following have been performed before connecting a computer and
projector to a network.
• Install EMP NS Connection on the computer you will be using.
• Prepare the computer settings to use either a wireless LAN card or
internal wireless LAN functionality. For setup, see the documentation for
the wireless LAN card installed in the computer, or the computer's
documentation.
• For optimal performance, set the screen resolution of the computer you
are using to XGA or lower with a colour depth of 16bit.
40
"Monitoring and Control Using EMP Monitor" in
p.17