Steps For Connecting Using Easy Connect Mode; Connection Settings On The Projector - Epson EasyMP EMP-7850 Guide De Mise En Route

Connecting Using Easy Connect Mode

Steps for Connecting Using Easy Connect Mode

Caution :
• Do not unplug the power cable when EasyMP is in use (screens are changing or the
access lamp on the wireless LAN card is lit green).
• Do not remove the wireless LAN card when the access lamp on the wireless LAN card is
lit green, or when connected to a network. Doing so may damage the wireless LAN card.

Connection Settings on the Projector

First, set up the Easy connect mode connection settings on this projector.
Connection settings are found on the Easy connect mode advanced settings screen
of the Network Screen.
Modify these connection settings using the remote control provided.
This step does not need to be performed if these settings have already been
established.
Procedure
1
Insert the wireless LAN card into the card slot on this projector.
See "Installation" for details.
2
Press the [Power] button on the remote control to turn on the projector.
3
Press the [EasyMP] button on the remote control. "EasyMP" will be
displayed on the screen.
EasyMP starts and the following screen is displayed.
22
ESSID ad hoc mode screenshot
p.14