Removal - Epson EasyMP EMP-7850 Guide De Mise En Route

Removal

Caution :
• Do not remove a PC card when the access lamp is lit green, when connected to a
network or when projecting a scenario. Improperly removing a PC card may result in
damage to the card or data destruction on a memory card.
• The PC card gets hot during and after projector use. Please handle the card carefully to
avoid personal injury or burns.
• When you wish to remove a memory card whilst using CardPlayer, be sure to close
CardPlayer before removal. CardPlayer may malfunction if a memory card is removed
without closing CardPlayer first.
Guide
Procedure
1
Press the eject button above of the card slot.
The eject button will pop out.
Card slot access
lamp
2
Press the eject button again.
Enough of the wireless LAN card will be ejected so that you can grasp the edge
of the card and pull it straight out of the slot.
Caution :
Be sure to press the eject button back in to prevent it from being broken or damaged.
"Closing CardPlayer" in the EasyMP Operation
Eject button
15