Epson EasyMP EMP-7850 Guide De Mise En Route page 28

8
When finished making setting changes, press the [
remote control, and move the cursor to "OK". Press the [Enter] button.
This applies the setting changes and returns to the Network advanced settings
screen.
9
Press the [ ] button on the remote control to move the cursor to "OK",
and press the [Enter] button.
This returns to the Connection Stand-by screen. The ESSID or channel number
that was set is displayed. If "Projector keyword" is "ON", the keyword is also
displayed.
Tip :
The projector keyword changes each time the projector power is turned OFF and ON
again, and when the wireless LAN card is removed and reinstalled. When connecting to
a computer, check the projector keyword displayed in the Connection Stand-by screen
and enter that keyword. Connection is not possible using a previous keyword.
] button on the
The value is displayed here.
27