Transmitting Encrypted Data - Epson EasyMP EMP-7850 Guide De Mise En Route

Transmitting Encrypted Data

When projecting images from a computer connected to a projector over a network,
image data can be encrypted and transmitted. Encryption of data ensures security.
However, it reduces baud rates.
Perform the following steps to use encrypted transmission.
Tip :
• Do not unplug the power cable when EasyMP is in use (screens are changing or the
access lamp on the wireless LAN card is lit green).
• Do not remove the wireless LAN card when the access lamp on the wireless LAN card is
lit green, or when connected to a network. Doing so may damage the wireless LAN card.
• For information about the Wired LAN card access lamp(s), refer to the documentation
of the wired LAN card you are using.
Procedure
1
This performs a connection setup between the projector and computer
in Access point mode.
2
On the computer select "Start" - "Programs" (or "All Programs") -
"EPSON Projector" - "EMP NS Connection".
EMP NS Connection starts.
Tip :
If EMP NS Connection is started while PowerPoint is also starting, the message
"Slideshow may not start without rebooting PowerPoint", will be displayed during
startup. If this occurs, close PowerPoint and restart it once EMP NS Connection has
finished starting.
3
Click the "Extension" button on the next screen.
p.41
71