Camera Introduction; Set Up The Camera - Reolink Go Mode D'emploi

Camera Introduction

Built-in Mic
Infrared Lights
Daylight Sensor
Lens
Status LED
Bult-in PIR Sensor
Speaker
Micro USB Port
Micro SD Card Slot
SIM Card Slot
Reset Hole
* Press the Reset button with a Pin to restore factory settings.
Battery Status LED
3 English

Set up the Camera

Activated the SIM Card for the Camera
• Choose a Nano SIM card that supports WCDMA and FDD LTE.
• Activate the card on your smartphone or with your network carrier before inserting
it into the camera.
NOTE:
• Some SIM cards have a PIN code, please use your smartphone to disable the PIN first.
• Do not insert the IoT or M2M SIM into your smartphone.
Register on Network
1. Remove the back cover by rotating
counterclockwise and insert the SIM
card into the slot.
2. Insert the battery into the camera
and tighten the back cover to power
on the camera.
English 4