Reolink Go Mode D'emploi page 4

3. A red LED will be on and solid for a
couple of seconds, then it will go out.
Initialize the Camera
Download and launch the Reolink App or Client software, and follow the onscreen
instructions to finish initial setup.
• On Smartphone
Scan to download the Reolink App.
• On PC
Download path of the Reolink Client: Go to
NOTE: Constant live streaming via the Client software or App will result in huge consumption of
cellular data.
5 English
4. "Network connection succeeded"
A blue LED will flash for a few seconds and
then go solid before going out, which means
the camera has been successfully connected
to the network.
https://reolink.com > Support > App&Client.
NOTE: You may also run into the following situations:
Voice Prompt Camera Status
"SIM card cannot be Camera cannot
1
recognized" recognize this SIM card.
"The SIM card is locked
with a PIN. Please Your SIM card has a PIN.
2
disable it"
"Not registered on
network. Please activate Camera fails to register
3
your SIM card and check to the operator network.
the signal strength"
"Network connection Camera fails to connect
4
failed" to the server.
"Data call failed. Please
The SIM card has run out
confirm your cellular
5 of data or APN settings
data plan is available or
are not correct.
import the APN settings"
Solutions
1. Check if the SIM card is facing
the reverse direction.
2. Check if the SIM card is not
fully inserted and insert it again.
Put the SIM card into your mobile
phone and disable the PIN.
1. Check whether your card is
activated or not. If not, please call
your operator to activate the SIM
card.
2. The signal is weak at the current
position. Please move the camera
to a location with better signal.
3. Check if you are using the
correct version of the camera.
The camera will be in Standby
mode and reconnect later.
1. Please check whether the data
plan for the SIM card is still
available.
2. Import the correct APN settings
to the camera.
English 6