Camera Introduction; Camera Connection Diagram - Reolink PoE Dome Camera Mode D'emploi

Camera Introduction

Mount
Metal Case
Lens
Infrared Lights
Daylight Sensor
Built-in Mic
Waterproof Lid
Network Cable
Reset Button
*Press and hold for 10seconds to restore camera to
factory settings.
Power Port(Optional)
3 English

Camera Connection Diagram

Before using the camera, please connect your camera as instructed
below to finish initial setup.
1. Connect the camera to a PoE injector with an Ethernet cable.
2. Connect the PoE injector to your router, and then power on the
PoE injector.
Router
Ethernet Cable
*You may also connect the camera to a PoE switch or Reolink PoE NVR.
PoE IP Camera
Ethernet Cable
PoE Injector*
Power Adapter
English 4