Illustrations; Preparing For Use - Miele Classic C1 SB 1 Série Mode D'emploi

en
Notes on Delegated Regulation
(EU) No. 665/2013 and
666/2013
This vacuum cleaner is a general pur‐
pose vacuum cleaner.
The adjustable floorhead supplied is
designed, when set to the carpet set‐
ting, for intensive vacuuming of carpets
as described in Delegated Regulation
(EU) No. 665/2013 and 666/2013.
The hard floorbrush, if supplied, is de‐
signed for intensive vacuuming of hard
floors with gaps and crevices as descri‐
bed in the above regulations. If this is
not supplied with your vacuum cleaner,
use the adjustable floorhead supplied in
the hard floor setting for intensive
cleaning of hard floors with gaps and
crevices as described in the above reg‐
ulations.
If your vacuum cleaner is also supplied
with a HEPA AirClean filter, please note
that it is suitable for use in all situations
described in the above regulations.

Illustrations

The illustrations referred to in the text
are shown on the fold-out pages at
the end of these operating instruc‐
tions.

Preparing for use

Attach the suction hose (dia. 01)
 Insert the hose connector into the
suction socket on the vacuum clea‐
ner until it clicks into position.
30
To detach the suction hose
 Press the release buttons at the side
of the hose connector, and lift the
hose from the socket.
Connect the suction hose to the han‐
dle (dia. 02)
 Fit the connector at the other end of
the suction hose into the handle until
it clicks into position.
Your vacuum cleaner is fitted with one
of the following tubes, depending on
model (see "Guide to the appliance"):
– EasyLock suction tube
– Telescopic suction tube
To assemble the EasyLock tube
(dia. 03)
 Hold the suction tube by the connec‐
tion piece and push it into the second
suction tube, turning it clockwise or
anti-clockwise until it clicks into posi‐
tion.
 Slide the connection piece upwards
until it clicks into position.
Connect the handle to the suction
tube (dia. 04)
 Insert the handle into the suction tu‐
be until it clicks into position. To do
this, line up the guides on the two pi‐
eces.
To detach the handle
 To detach the handle from the sucti‐
on tube, press the release button
and pull the handle out of the sucti‐
on tube, twisting it slightly as you do
so.