Replacing One Type Of Exhaust Filter With Another; When To Replace The Active Airclean 30 / Hepa Airclean 30 Filter; How To Replace The Exhaust Filter Active Airclean 30 / Hepa Airclean 30; When To Change The Thread Lifters - Miele Classic C1 SB 1 Série Mode D'emploi

en
 Release the filter grille and raise it
upwards. Grasp the used AirClean
filter by the clean, unsoiled section
(see arrow) and take it out.
 Replace it with a new filter.
 Close the filter grille.
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on model, your vacuum
cleaner may also be supplied with an
Active AirClean 30 or HEPA AirClean 30
filter which can be fitted instead of the
standard AirClean filter.
In order to use either of these filters you
first have to remove the AirClean filter
and the filter grille and replace these
with the new filter. You will also need to
press the exhaust filter change indicator
to activate it (dia. 23).
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 24).
When to replace the Active AirClean
30 / HEPA AirClean 30 filter (dia. 25)
Replace if the display for the exhaust
filter change indicator is completely fil‐
led with red. This occurs after approx.
50 hours of operation which is equiva‐
lent to about a year of average use. The
vacuum cleaner can still be used. How‐
ever, the suction power will be reduced
as will the effectiveness of the filter if it
is not replaced in good time.
36
How to replace the exhaust filter
Active AirClean 30 / HEPA AirClean
30 (dia. 26)
 Lift out the old exhaust filter.
 Replace it with a new filter.
 Press the exhaust filter change indi‐
cator (dia. 23).

When to change the thread lifters

The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters

(dia. 27)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 28)
 Release the bearing (with bayonet
fitting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, lo‐
cking it back into position.
Replacement parts are available from
your Miele Dealer or from Miele (see
end of booklet for contact details).