After Sales Service; Guarantee; Electrical Connection For The Uk; Electrical Connection Au, Nz - Miele Classic C1 SB 1 Série Mode D'emploi

en

After sales service

In the event of a fault that you cannot
easily remedy, please contact your
Miele Dealer or Miele (see end of book‐
let for contact details).
Please note that telephone calls may
be monitored or recorded for training
purposes (UK only).

Guarantee

The appliance is guaranteed for a peri‐
od of 2 years from the date of pur‐
chase. In the UK you must activate your
cover by calling 0330 160 6640 or reg‐
istering online at www.miele.co.uk.
For information on the appliance guar‐
antee specific to your country please
contact Miele. See end of booklet for
contact details.
Electrical connection for
the UK
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
national and local safety regulations
(BS 7671 in the UK). The voltage and
frequency are given on the data plate
located underneath the vacuum clean‐
er. Please ensure that these match the
household mains supply. The fuse rat‐
ing is quoted on the plug. The appli‐
ance is supplied with a cable and moul‐
ded plug ready for connection to a
230-240 V/50 Hz a.c. single phase sup‐
ply.
Non-rewireable plugs BS 1363
38
The fuse cover must be re-fitted when
changing the fuse, and if the fuse cover
is lost the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is em‐
bossed in words on the base of the
plug, (as applicable to the design of
plug fitted). Replacement fuses should
be ASTA approved to BS1362 and have
the correct rating. Replacement fuses
and fuse covers may be purchased
from your local electrical supplier.
Electrical connection AU,
NZ
All work should be carried out by a suit‐
ably qualified and competent person in
strict accordance with national and lo‐
cal safety regulations. The voltage and
rated load are given on the data plate
located underneath the vacuum clean‐
er. Please ensure that these match the
household mains supply. The fuse rat‐
ing is quoted on the plug. The appli‐
ance is supplied with a cable and moul‐
ded plug ready for connection to a
230V/50Hz AC single phase supply.
Test Marks
Electrically sup‐
pressed
according to
Electrical safety
RCM Mark
AS/NZS CISPR
14.1