Problem Solving Guide; After Sales Service - Miele HS08 Mode D'emploi

,
Do not let the vacuum cleaner
get wet. If moisture gets into the
appliance, there is a risk of electric
shock.

Problem solving guide

The vacuum cleaner switches off
automatically.
Vacuum cleaners with a rotary selector
dial: The vacuum cleaner in-operation
indicator lights up red.
Vacuum cleaners with +/- buttons: The
thermal cut-out indicator lights up red.
The overheating protection mechanism
has been activated due to overheating
or a blockage.
^ Switch the Electrobrush and the
vacuum cleaner off, switch it off at
the wall socket and remove the plug.
^ Check the vacuum cleaner for any
blockages and check all the filters in
the vacuum cleaner.
Once the blockage has been removed
do not use the vacuum cleaner for
about 20 - 30 minutes to allow it to cool
down.
The Electrobrush switches off
automatically. The Electrobrush
indicator lights up red.
The red light indicates a blockage in
the roller, for example due to a large
item being vacuumed up.
^ Switch the Electrobrush and the
vacuum cleaner off, switch it off at
the wall socket and remove the plug.
^ Remove the blockage.
The vacuum cleaner can then be used
again.
The Electrobrush switches off
automatically. The Electrobrush
indicator stays yellow.
The overheating protection mechanism
has been activated due to overheating
or a blockage.
^ Switch the Electrobrush and the
vacuum cleaner off, switch it off at
the wall socket and remove the plug.
^ Check the vacuum cleaner for any
blockages and check all the filters in
the vacuum cleaner.
The Electrobrush has to cool down. To
speed this up:
^ Switch the vacuum cleaner back on.
^ Vacuum for approx. 10 minutes
without switching the Electrobrush
on.
This will cool the Electrobrush down so
that it can then be used again as
normal.

After sales service

In the event of a fault that you cannot
easily remedy, please contact
– your Miele Dealer, or
– Miele (see end of booklet for contact
details)
en
45