Remove Hybrid Filters; Install Glass Panels - Best ICB3I Serie Instructions D'installation

6. REMOVE HYBRID FILTERS

Rest the range hood on a table. Protect the table to avoid damaging it. Remove
tape on filters. Lift filters by pushing them towards the back of the hood (opposite
to control side) and flip, then set filters aside.

7. INSTALL GLASS PANELS

The SBN hood model decorative glass panels are sold separately and have to be installed before completing the hood installation.
1. Carefully remove glass panel from its packaging. Remove glass panel nuts (factory installed) from both studs and set aside.
2. Insert glass panel studs in appropriate hood holes.
NOTE: Install the glass panel with the control pictograms on
the front of the hood.
3. While holding glass panel, pre-tighten the previously removed
nuts by hand. Ensure glass panel is centered. Then, using a
3/8" socket, tighten nuts completely.
4. Repeat the same steps for the second glass panel installation.
(SBN MODEL ONLY)
F
RONT GLASS PANEL
STUDS LOCATION
R
EAR GLASS PANEL
STUDS LOCATION
7
HO0349
HD0568
N
UT
G
LASS PANEL
STUD
HD0558
HD0569