Maintenance; Scheduled Maintenance Table; Squeegee Cleaning - Nilfisk Advance Micromax 17E Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTRUCTIONS FOR USE

MAINTENANCE

The following table summarizes the routine maintenance required. The intervals indicated can be changed to suit working
conditions. These must be defined by the person in charge of the maintenance.
WARNING!
The operations must be carried out with the machine off and disconnected from the electrical mains.
Moreover, carefully read the instructions in the Safety chapter before performing any maintenance
operation.
All routine or extraordinary maintenance operations must be performed by skilled personnel, or by an authorized Service Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures contained in the Scheduled Maintenance Table see the specific Service
Manual that can be consulted at the Advance Service Center.

SCHEDULED MAINTENANCE TABLE

Operation
Supply cable integrity check

Squeegee cleaning

Squeegee blade check (and replacement)
Brush cleaning
Tank and vacuum grid with float cleaning
Solution filter cleaning
Nut and screw tightening check
Vacuum electrical motor brush (or carbon brush)
check or replacement
(1): And after the first 8 working hours
(2): Maintenance operation to be performed by the Advance Service Center
SQUEEGEE CLEANING
NOTE
For a good drying, the squeegee must be clean and its blades must be in good conditions.
CAUTION!
It is advisable to wear protective gloves when cleaning the squeegee because there can be cutting debris.
1.
Drive the machine on a level ground.
2.
Check that the switches (2 and 3, Fig. B) are in "0" position.
3.
Lower the squeegee (10) by means of the lever (19, Fig. C).
4.
Disconnect the vacuum hose (25, Fig. C) from the squeegee.
5.
Loosen the knobs (11, Fig. C) and remove the squeegee (10).
6.
Wash and clean the squeegee; in particular, clean the compartments (1, Fig. D) and the hole (2) from dirt and debris. Check
that the front (3) and rear blades (4) are integral and free from cuts and lacerations; otherwise replace them (see the
procedure in the following paragraph).
7.
Install in the reverse order of removal.
8
All manuals and user guides at all-guides.com
Daily, before
Daily, after
machine use
machine use
Every six
Weekly
months
Micromax™ 17E — 909 5473 000(2)2005-04
Yearly
(1)
(2)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

908 7047 020

Table des Matières