Automatic Power Off - koban KPA-11T Manuel D'instructions

EN
1. If one Reading displays a value (typically 0.400V to 0.900V) and the other Reading displays "OL", the
diode is good.
2. If both readings display "OL", the device is open.
3. If both readings are very small or "OL" the device is shorted.
7.9 Data Hold
To freeze the LCD Reading, press the HOLD button. While data hold is active the HOLD icon appears on the LCD.
Press the HOLD button again to return to normal operation.
7.10 Relative
- Press the REL button to zero the display, will appear in the display
actual value less the stored "zero" value.
- Press the REL button to view the stored value
- To exit this mode, press and hold the REL button until
7.11 Peak Hold
The Peak Hold function captures the peak AC or DC voltage or current. The meter can capture negative or pos-
itive peaks as fast as 1 millisecond in duration.
- Turn the function switch to the A or V position.
- Use the MODE button to the AC or DC.
- Allow time for the display to stabilize.
- Press the PEAK button, PEAK will display.
- The display will update each time a higher positive peak occurs.
NOTE: If the function switch position is changed after a calibration the Peak Hold calibration must be repeated
for the new function selected.
7.12 LCD backlight button
The LCD is equipped with backlighting for easier viewing, especially in dimly lit areas. Press the PEAK button
for over 1 second to turn the backlight on. Press again for over 1 second to turn the backlight off.

7.13 Automatic Power OFF

In order to conserve battery life, the meter will automatically turn off after approximately 15 minutes. To turn
the meter on again, turn the function switch to the OFF position and to the desired function position.
The displayed reading is now the
will flash in the display.
is no longer in the display.
KPA-11T
TRMS CLAMP METER
33 / 46