Cable Locator Mode; Automatic Mode - koban KCL-01 Mode D'emploi

KCL-01
• Disconnect the transmitter from all connected measurement circuits.
• Switch on the transmitter.
• Set transmission level I.
• Perform a single-pole connection of one test lead to socket 1.
• Switch on the receiver. Search for the signal at the cable and place the sensor head on
the cable.
• Insert the open cable end into connection socket 2.
Receiver
1: Sensor head
2: Flashlight
3: LCD display
4: NCV button (Non-contact voltage detection)
to select between cable locator mode and
mains voltage detection mode
5: Flashlight button
6: Downward selection
Toggle button for manual selection of the
sensitivity
7: Mode button to selective automatic or
manual mode
8: Backlight/Beeper ON/OFF button
9: Upward selection
Toggle button for manual selection of the
sensitivity
10: Power ON/OFF button
11: Battery case
5
EN EN
Receiver - Display
a: The indication of the acoustic display
switched off
b: The active LCD illumination indicator
c: Information transmitted by the transmitter
(transmission code and battery charge
condition)
d: The indication of the automatic mode
switched on
e: The signal intensity indicator with bargraph
f: Low battery indication
g: Manual mode: additional graphic display
to show the selected sensitivity Display
of the sen-sitivity within the selective mode.
Large magnifying glass => high sensitivity,
Small magnifying glass => low sensitivity
h: The manual mode active indicator
i: Mains voltage display
j: Automatic mode; digital display for signal intensity / manual mode.
k: Transmission level transmitted by the transmitter (LEVEL I, II, or III)
L: The indication of the mains voltage detection switched on

2.3 Cable Locator Mode

Automatic Mode

When the automatic mode is selected the symbol "SIG"
is displayed.
KCL-01
Automatic Mode
6