Stiga Park 4WD Serie Manuel D'utilisation page 162

EN
9.11.2 Replace the spark plug
For the frequency of this intervention
see chapter 13.
Before removing the spark plug, clean around its
mounting.
For the type of spark plug and relative spark gap,
please refer to "0 TECHNICAL DATA TABLE".
9.11.3 Cleaning the air intake.
For the frequency of this intervention
see chapter 13.
See figure (21:C).
The engine is air-cooled.
A blocked cooling system can damage the engine.
More meticulous cleaning of the cooling system
should be carried out during each basic service.
9.12 LUBRICATION (30)
For the frequency of this intervention
see chapter 13.
Object Action
Centre 4 grease nipples
Use a grease nipple filled
point
with multi-purpose grease.
Pump until the grease
seeps out.
Steering Brush the chain clean
chains with a wire brush.
Lubricate with universal
chain spray.
Tensioning Lubricate the support
points with oil
arms
when each control is
activated.
Ideally this operation
should
be carried out by two
people.
Control Lubricate the cable ends
with oil
cables
when each control is
activated.
This operation must be
carried out by two people.
22
All manuals and user guides at all-guides.com
Fig.
30A
-
30B
30C
ENGLISH
(Translation of the Original Instructions)
9.13 FUSES (5:A)
Destination
Electrical system power supply 20 A
10 ASSISTANCE AND REPAIRS
This manual provides all the necessary infor-
mation to run the machine and for correct basic
maintenance operations which can be performed
by the user.
Any regulations and maintenance operations not
described herein must be carried out by your De-
aler or Authorized Service Centre, which have the
necessary knowledge and equipment to ensure
that the work is carried out correctly, maintaining
the correct degree of safety and the original opera-
ting conditions of the machine.
Before performing any servicing opera-
tions:
a. Place the machine on a flat surface.
b. Activate the parking brake (12:B)
c. Stop the engine.
d. Remove the key from the ignition.
Authorized service workshops carry out guaran-
teed repairs and maintenance.
Always use genuine spare parts.
Genuine GGP spare parts and accesso-
ries have been designed specifically for
GGP machines.
Please remember that non-genuine
spare parts and accessories have not
been verified or approved by GGP.
The use of non-genuine spare parts
and accessories could adversely affect
machine operation and safety.
GGP shall decline all liability in the
event of injuries or damages caused by
such parts.
Genuine spare parts are supplied by
authorized assistance workshops and
dealers.
It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance and
safety device inspection.
Fuse