Stiga Park 4WD Serie Manuel D'utilisation page 160

EN
The drain plug might get damaged if
it is tightened to a torque exceeding 5
Nm.
11. Draw out the fluid from the deepest part of
the reservoir using a fluid extractor (26).
12. Dispose of the oil according to local regula-
tions.
Filling with fluid
1. Fill the fluid reservoir with fresh fluid.
2. Check that the rear axle's clutch release
lever is disengaged. Move the lever (15 A) in
position A2.
Place two wooden planks (4-5 cm thick)
in front of the rear wheels (so they are
touching the tyres)to make sure the
machine stays stationary during the fol-
lowing operations.
3. Release the parking brake. Fully depress and
release the accelerator pedal (12: B).
WARNING: the following operations
must be performed with the engine
bonnet open and the engine running.
Keep hands well away from moving
parts.
4. Start the engine. When the engine is started,
the front axle's clutch release lever automati-
cally slides inwards.
Never start the engine when the rear
axle clutch release lever is engaged
and the front axle clutch release lever
is disengaged (15:A) (15:B). This could
damage the front axle gaskets.
If the engine is run indoors, exhaust ex-
traction equipment must be connected
to the engine's exhaust pipe.
5. Disengage the front axle's clutch release le-
ver. Move the lever (15: B) in position B2.
NOTE! The oil is drawn into the system
very quickly. The tank must be filled up
in a continuous manner until it remains
full in order to fill the circuit and make
sure air is not drawn into the system
(something which must never be allo-
wed to happen).
6. Set the accelerator pedal to the forward posi-
tion, locking it using a wooden wedge (28).
7. Run in the forward position for one minute.
8. Move the wooden wedge and set the accele-
rator pedal to the reverse position. Continue
filling with oil.
9. Run in reverse mode for one minute.
20
All manuals and user guides at all-guides.com
ENGLISH
(Translation of the Original Instructions)
10. Change driving direction every minute as
indicated above and continue filling with oil
until the bubbling in the reservoir stops.
11. Switch off the engine, replace the cover
(23:B) on the fluid tank and close the bonnet.
12. Activate the machine at various speeds for
several minutes and adjust the fluid level in
the tank if necessary.
9.8 BELT TRANSMISSIONS CHECK
check that all belts are intact.
For the frequency of this intervention
see chapter 13.
9.9 STEERING
For the frequency of this intervention
see chapter 13.
9.9.1 Checks
Gently turn the steering wheel back and forth.
There must be no mechanical play in the steering
chains.
9.9.2 Adjustment (29)
Adjust the steering chains if required as follows:
1. Put the machine in the straight-ahead posi-
tion.
2. Adjust the steering chains by means of the
two nuts, located under the central point (29).
3. Adjust both nuts by the same amount until
there is no play.
4. Test drive the machine, moving it forward in
a straight line and checking that the steering
wheel is not off centre.
5. If the steering wheel is off centre, slacken
one nut and tighten the other.
Do not over tension the steering chains.
This would make the steering too stiff
and increase wear on the chains.
9.10 BATTERY
For the type of battery installed on the machine,
please refer to "0 TECHNICAL DATA TABLE"
CAUTION! Battery acid is corrosive and
contact with it is harmful.
Handle the battery with care taking care
not to let acid leak out.
Acid can cause serious injuries if it co-
mes into contact with eyes or skin. If
any part of the body comes into contact