Babboe Mountain Manuel D'utilisation page 30

TIP
• Charging will start automatically.
• If the display unit is turned on while the battery pack is
charging, all normal displays will be shown, including the
battery capacity indicator, but the assist system will not
function.
• When the battery pack is connected to the battery charger,
the battery charger lamp will flash at approximately 0.2
second intervals to indicate that the battery pack is being
prepared to be charged. Leave it alone and charging will
start normally.
If a charging fault occurs during charging,
remove the power plug of the battery charger from the socket
and wait for the battery pack/battery charger to cool.
Charging the battery with battery pack removed
from the bike
1. Turn the system off with the on/off switch.
2. Use the key from your bike's ring lock to open the lock of the
battery pack. The key can be removed from the ring lock
after locking your bike.
Removing the battery back from the box:
3. Put the key in the battery pack lock and turn it to the right to
unlock it.
4. Remove the battery pack by pulling it sideways to the left
(using the handle) and then lifting it up and out of the
plug holder.
5. The key can now be removed from the battery pack lock by
turning it to the left. Put the key back in the bike's ring lock.
6. Remove the cap from the battery pack's charging contact and
connect the plug of the charger's cable to the charging contact.
PLEASE NOTE:
Do not connect the charging cable's plug to the battery pack's
charging contact when it is wet.
This can seriously damage the battery pack. Only connect the
charger's cable plug when all connections are completely dry. Do
not apply excessive force to the plug and do not pull the charger
cable while the plug is connected to the charging contact as this
may damage the plug or the cable.
58
7. See "Reading the charging status for battery pack", and check
that the battery charger is charging the battery pack.
8. The battery capacity indicator lamps will light up one by
one until all four are on. Then, when charging is complete, all of
the lamps will go off.
9. Confirm that charging is complete, and then disconnect the charging
plug from the battery pack. How to disconnect the plug (see the left figure)
1 . Grasp the lock-release ring.
2. Pull it out straight.
6. Place the cap of charging inlet on the battery pack's charging connector.
• Do not touch charger contacts with metallic objects. Do not allow foreign material to cause short circuit of the
contacts. This could result in electric shock, fire, or damage the battery charger.
• Periodically remove dust from the power plug. Dampness or other issues could reduce the effectiveness of the
insulation, resulting in fire.
• Never disassemble or modify the battery charger. This could result in fire or electric shock.
• Do not use with a power strip or extension cord. Using a power strip or similar methods may exceed rated
current and can result in fire.
• Do not use with the cable tied or rolled up, and do not store with the cable wrapped around the charger main
body. Cable damage can result in fire or electric shock.
• Firmly insert the power plug and the charging plug into the socket. Failure to insert the power plug and
the charging plug completely can result in fire caused by electric shock or overheating.
• Do not use the battery charger near flammable material or gas. This could result in fire or explosion.
• Never cover the battery charger or place other objects on top of it while charging. This could result in internal
overheating leading to fire.
• Do not short the contacts of the battery pack. Doing so could cause the battery pack to become hot or catch
fire, resulting in serious injury or property damage.
• Do not disassemble or modify the battery pack. Doing so could cause the battery pack to become hot or catch
fire, resulting in serious injury or property damage.
• Do not dispose of the battery pack in a fire or expose it to a heat source. Doing so could cause an explosion,
resulting in serious injury or property damage.
• Do not drop the battery pack or subject it to impact. Doing so could cause the battery pack to become
hot or catch fire, resulting in serious injury or property damage.
NOTICE
Make sure there is no foreign matter on the battery pack contacts before inserting the battery pack.
6. Raadp
Ring vrijgave vergrendeling Lock-release ring
7. De ind
8. Contro
9. Plaats
10. Beves
• Raak d
• Verwij
• Demon
• Gebru
• Gebru
• Steek
• Gebru
• Bedek
OPMERK
Geleider Accu-uiteinde
Plaatsing
De accu w
• Plaats
• Schuif
X0S7_EPAC欧州向け蘭語_MY19.indd 38
en con
één ga
gens z
jes uit
gens d
Hoe d
ding)
Pak
Trek
len ob
kortslu
den to
lader b
kunne
tiviteit
tot bra
kan le
lengsn
lijkbar
schrijd
den of
de op
kan le
stopc
niet vo
in bran
ting.
brandb
of een
re obje
Dit ka
kan ve
klik ho
38
59