Reversing The Access Door - Hatco Flav-R-Savor FSD-1 Manuel D'installation Et D'utilisation

INSTALLATION

Reversing the Access Door

Flav-R-Savor Humidified Holding and Display Cabinet
access door(s) may be hinged on either the left or right side
for convenience. Use the following procedure to reverse the
access door.
NOTE: The last four digits in a ten digit numerical serial number
are the manufacturing date code.
Example: Serial number 9625061331 has a date code
of "1331" which indicates:
NOTE: For models with a date code of 1829 or older and
equipped with a motorized rotating rack (FSD-1,
FSD-2, FSDT-1, and FSDT-2), the "Relocating the
Proximity Switch" procedure in this section must be
performed after reversing the access door(s).
1. Remove the top hinge pin screw holding the door to the
hinge.
2. Tip the door assembly forward (away from cabinet) and
lift gently to clear the bottom hinge assembly. Remove the
nylon washer(s).
3. Reinstall the top hinge pin screw.
1331
Week Thirty-One
Year 2013
Hinge Assembly
Reversing the Access Door
4. Remove the fluorescent lamp cover to allow access to the
hinge bracket/striker plate hardware, if necessary.
5. Remove the screws holding the hinges to the cabinet.
6. Remove the screws from the striker plates on the non-
hinge side of the cabinet.
7. Install the striker plates on the opposite side of the cabinet
where the hinges were previously mounted.
8. Install the hinges on the opposite side of the cabinet
where the striker plates were previously mounted using
the original hinge mounting screws.
9. Replace the fluorescent lamp cover, if necessary.
10. Carefully rotate the door 180°.
11. Remove the hinge pin screw from the end that is now the
top.
12. Carefully place the door assembly with the nylon washer(s)
into the bottom hinge.
13. Tip/tilt the door assembly towards the cabinet and align the
door top with the hinge. Reinstall the top door hinge pin
screw through the hinge and into the door top.
Striker Plate and
Hardware
Top Hinge
Pin Screw
8
English
Door Rotated 180°
Bottom Hinge Pin Screw and
Nylon Washer(s)
Form No. FSDM-0119