Reversing The Access Door - Hatco FSHC-6W Série Manuel D'installation Et D'utilisation

INSTALLATION

Reversing the Access Door

Doors are shipped from the factory hinged on the left side of
the cabinet, opening from the right. Use the following procedure
to reverse the door to open from the left.
1. Remove the top hinge screw.
2. Tip the door forward (away from cabinet) and lift gently to
clear the bottom hinge bracket. make sure to locate and
save the nylon washer.
3. Reinstall the hinge screw that was removed in the first step.
4. Remove the hinge bracket screws securing each hinge
bracket to the cabinet.
5. Remove the hinge cover and hinge cover screws from the
right side of the cabinet and install them into the left-side
screw holes.
6. Reinstall the hinge bracket on the right side of cabinet.
7. Rotate the door 180°.
Hinge Bracket Screws
Hinge Bracket
Hinge Screw
Nylon
Washer
Glass
Access Door
Removing the access Door
Hinge Cover
Hinge Cover Screws
Door
Handle
Handle Screws
Nylon Washer Nylon Washer
Bracket Screws
Door
Plug
Hinge Screw
Reversing and Installing the access Door
8. Remove the hinge screw from the end of the door now at
the top.
9. Place the door assembly into the bottom hinge bracket.
NOTE: Nylon washer must be installed between the door and
the bottom hinge bracket.
10. Tip/tilt the door assembly towards the cabinet and align the
door top with the hinge bracket. Reinstall the top hinge
screw through the top hinge bracket and into the door.
Tighten securely.
11. Remove the door handle by removing the door handle
screws from the backside of the door.
12. Remove the door plug from the top hole of the door.
13. Install the door plug into the bottom hole of the door by
pressing firmly.
14. Install the handle by aligning the screw holes on the handle
to the screws in the top two holes of the door.
Hinge
Hinge Cover
Cover
Screws
Hinge
Hinge Bracket
8
English
Form No. FSHC67m-0714